Siemens SIMATIC NET Configuration Manual page 202

Network structures
6.1 WLAN
Syntax
Call up the command with the following parameters:
wlan mode { show-modes | [2.4 | 5] <mode>}
The parameters have the following meaning:
Parameters Description
show-
modes
2.4
5
mode
Depending on the current configuration, some settings are not possible. In this case, a
message to this effect is displayed.
Result
The transmission standard is specified.
Further notes
You display the setting with the
202
Lists the transmission standards.
Optional. You can use the parameter in
conjunction with "auto" and "n". This
only takes into account the transmis-
sion standard for 2.4 GHz.
Use the parameter if the client operates
in dual-frequency mode.
Optional. You can use the parameter in
conjunction with "auto" and "n". This
only takes into account the transmis-
sion standard for 5 GHz.
Use the parameter if the client operates
in dual-frequency mode.
Value corresponding to a specific
transmission standard.
show wlan basic <wlan 0/X>
Range of values / note
--
--
--
•
auto
The transmission standard is detected
automatically.
•
a
IEEE 802.11a (5 GHz)
•
g
IEEE 802.11g (2.4 GHz)
Is downwards compatible with IEEE
802.11b
•
n
IEEE 802.11n (2.4 GHz + 5 GHz)
Is downwards compatible with IEEE
802.11a and IEEE 802.11g
•
n-only
IEEE 802.11n (2.4 GHz + 5 GHz)
Is not downwards compatible with IEEE
802.11a and IEEE 802.11g
command.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05