10.2.3
Commands in the WLAN Interface configuration mode
This section describes commands that you can call up in the WLAN Interface Configuration
mode. Depending on the Interface selected, various command sets are available.
In the Global Configuration mode, enter the
mode.
● If you exit the WLAN Interface Configuration mode with the
the Global Configuration mode.
● If you exit the WLAN Interface Configuration mode with the
the Privileged EXEC mode.
10.2.3.1
wlan security edit key
Description
With this command, you add a WEP or AES key to the key table. You can choose between
several key lengths.
● 5 or 13 ASCII or 10 or 26 hexadecimal characters specify a weaker key (40/104 bits).
● 16 ASCII or 32 hexadecimal characters, on the other hand, define a strong key (128 bits).
Note
iPCF or iPCF-MC mode activated
If you want encryption with AES in iPCF or iPCF-MC mode, only keys with a 128 bit key
length are supported.
Requirement
You are in the Interface configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan security edit key <index(1-4)> <key>
The parameters have the following meaning:
Parameter
index
key
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
interface wlan 0/X
Description
Index of the key table
Key
Security and authentication
10.2 WLAN
command to change to this
command, you return to
exit
command, you return to
end
Range of values / note
1...4
Enter the WEP or AES key.
403