No Smtp-Port; Http Server; The "Show" Commands - Siemens SIMATIC NET Configuration Manual

7.5.2.6

no smtp-port

Description
With this command, you reset the SMTP port to the default.
The default value is 25.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call the command without parameters:
no smtp-port
Result
The SMTP port is reset to the default value.
Further notes
You configure the setting with the
You display the setting with the
7.6

HTTP server

This section describes commands of the Hypertext Transfer Protocol (HTTP).
7.6.1

The "show" commands

This section describes commands with which you display various settings.
With the command
configuration mode.
To do this, you replace
Example
do show cli-console-timeout
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
smtp-port
show smtp-port
you can execute the "show" commands in every
do [command]
with the "show" command that you want to execute.
[command]
command.
command.
Network protocols
7.6 HTTP server
359