Sinema; The "Show" Commands; Show Sinema; Commands In The Global Configuration Mode - Siemens SIMATIC NET Configuration Manual

3.5

SINEMA

3.5.1

The "show" commands

This section describes commands with which you display various settings.
With the command
configuration mode.
To do this, you replace
Example
do show cli-console-timeout
3.5.1.1

show sinema

Description
This command shows whether the SINEMA configuration interface is enabled or disabled.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show sinema
Result
The setting of the SINEMA configuration interface is displayed.
3.5.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
do [command]
[command]
or
cli#
you can execute the "show" commands in every
with the "show" command that you want to execute.
configure terminal
or
end exit
command to change to this mode.
command and are then in the
Configuration
3.5 SINEMA
87