Show Interface Mtu - Siemens SIMATIC NET Configuration Manual

Configuration
3.1 System
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available counters.
Result
The counters of the selected interfaces are displayed.
3.1.1.8

show interface mtu

Description
With this command, you show the setting for the Maximum Transmission Unit (MTU) of the
interfaces on the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show interface mtu [{Vlan<vlan-id(1-4094)>|
The parameters have the following meaning:
Parameter
Vlan
vlan-id
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If no parameters are specified, the settings for all interfaces are displayed.
Result
The settings are displayed.
40
or
cli#
<interface-type><interface-id>}]
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Range of values / note
-
1 ... 4094
Enter a valid interface.