Wlan Signal-Recorder Display Sample_Number (Client) - Siemens SIMATIC NET Configuration Manual

Functions specific to SCALANCE
4.2 Signal recorder
Syntax
Call up the command with the following parameters:
wlan signal-recorder <wlan 0/X> <ms (100 - 60000)> display
The parameter has the following meaning:
Parameter
wlan 0/X
ms
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The recording is configured and will be started. The measured values are output in the CLI
and logged in files. If these files already exist, they will be overwritten.
Use the
During the recording, it is possible that working in the CLI becomes slower.
Further notes
You stop the recording early with the
You display the status of the signal recorder and the recording with the
recorder <wlan 0/X>
4.2.5

wlan signal-recorder display sample_number (Client)

Description
With this command, you configure and start recording with the signal recorder. The
measured values are output in the CLI and logged in files. On completion of the recording,
the files can be downloaded as a zip file using http or tftp. The values are stored every 10
minutes. The file contains all values since the start of the recording.
Note
This command is only available in the client mode.
98
Description
WLAN interface
The interval in milliseconds (ms) be-
tween acquisition of two measured
values
wlan signal-recorder <wlan 0/X> stop
command.
Range of values / note
Enter a valid interface.
100 - 60000
command to stop the recording.
wlan signal-recorder <wlan 0/X> stop
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.
show wlan signal-