3.2.5.2
tftp filename
Description
With this command, you assign a name to a file type.
The file type decides the type that is affected by the
name decides the file to be copied to or from the TFTP server.
Requirement
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Syntax
Call up the command with the following parameters:
tftp filename {showfiles|filetype< filetype >name<filename>}
The parameters have the following meaning:
Parameter
showfiles
filetype
filetype
name
filename
Result
The file types are displayed or the file type is assigned a name.
Further notes
With the "
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
Shows the available files
Keyword for a file type to be assigned
a name
Name of the file type
Keyword for a file name to be assigned
to the file type
Name of the file
" command, you can display the file types.
show loadsave files
3.2 Load and Save
or
tftp load
tftp save
Range of values / note
-
-
max. 100 characters
-
max. 100 characters
Configuration
action. The
75