No Wlan Security Encryption (Client) - Siemens SIMATIC NET Configuration Manual

10.2.4.10

no wlan security encryption (client)

Description
With this command, you disable encryption with a fixed (unchanging) WEP key. This setting
is activated as default. You can only enable or disable encryption if you have selected "Open
System" for authentication.
Note
This command is only available in the client mode.
Requirement
● The type of authentication is "
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan-context-x)#
Syntax
Call the command without parameter assignment:
no wlan security encryption
Result
The encryption is disabled.
Further notes
You display the settings with the
You enable the encryption with the
See also
wlan security encryption (client) (Page 414)
wlan security authentication (client) (Page 405)
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
".
open-system
command.
show wlan security
wlan security encryption
Security and authentication
10.2 WLAN
command.
415