System time
5.3 SNTP client
Syntax
Call the command without parameters:
sntp
Result
You are now in the SNTP configuration mode.
The command prompt is as follows:
cli(config-sntp)#
Further notes
You exit the SNTP configuration modewith the
5.3.3
Commands in the SNTP configuration mode
This section describes commands that you can call up in the SNTP configuration mode.
In the Global configuration mode, enter the
● If you exit the SNTP configuration mode with the
configuration mode.
● If you exit the SNTP configuration mode with the
Privileged EXEC mode.
126
or
command.
end
exit
command to change to this mode.
sntp
command, you return to the Global
exit
command, you return to the
end
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05