Commands In The Security Context Configuration Mode; Wlan Security Authentication (Client) - Siemens SIMATIC NET Configuration Manual

10.2.4

Commands in the security context configuration mode

This section describes commands that you can call up in the security context configuration
mode.
In the WLAN configuration mode, enter the
change to this mode.
● If you exit the security context configuration mode with the
the WLAN configuration mode.
● If you exit the security context configuration mode with the
the Privileged EXEC mode.
10.2.4.1

wlan security authentication (client)

Description
With this command, you specify the type of authentication.
Note
This command is only available in the client mode.
Note
iPCF or iPCF-MC mode enabled
If iPCF or iPCF-MC mode is enabled, only "Open System" with the encryption method AES
is supported in the security settings.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan-context-x)#
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Security and authentication
wlan security context <ID (1-8)>
exit
command, you return to
end
10.2 WLAN
command to
command, you return to
405