Switchport Ingress-Filter - Siemens SIMATIC NET Configuration Manual

Requirement
You are in the interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport access vlan
Result
The setting is reset to the default value.
Further notes
You configure the setting with the
You can display the status of this function and other information with the
config
6.2.3.4

switchport ingress-filter

Description
With incoming packets, the ingress filter checks whether the port on which the packet was
received belongs to the sending VLAN. If this is not the case, the packet is not processed.
With this command, you enable the ingress filter.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
switchport ingress-filter
Result
The ingress filter is activated.
Further notes
You disable the filter with the
You can display the status of the ingress filter and other settings with the
config
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.
command.
switchport access vlan
no switchport ingress-filter
Network structures
command.
show vlan port
command.
show vlan port
6.2 VLAN
231