Show Wlan Data Rates (Access Point) - Siemens SIMATIC NET Configuration Manual

Network structures
6.1 WLAN
The parameter has the following meaning:
Parameter
vapX 0/Y
AID
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The table with the logged-on clients is displayed.
6.1.1.11

show wlan data rates (access point)

Description
This command shows the tables with the available data transmission speeds.
Note
This command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show wlan data rates <wlan 0/X>
The parameter has the following meaning:
Parameter
wlan 0/X
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
140
Description
VAP interface
Connection ID of the
client.
or
cli#
Description
WLAN interface
Range of values / note
Enter a valid interface.
-
Range of values / note
Enter a valid interface.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05