Commands In The Wlan Configuration Mode; Device Mode - Siemens SIMATIC NET Configuration Manual

Network structures
6.1 WLAN
6.1.4

Commands in the WLAN configuration mode

This section describes commands that you can call up in the WLAN configuration mode.
In the Global Configuration mode, enter the
Commands relating to other topics that can be called in the WLAN configuration mode can
be found in the relevant sections.
● If you exit the WLAN configuration mode with the
configuration mode.
● If you exit the WLAN Configuration mode with the
Privileged EXEC mode.
6.1.4.1

device mode

Description
With this command, you specify the mode of the SCALANCE W700 device.
Requirement
You are in the WLAN Configuration mode.
The command prompt is as follows:
cli(config-wlan)#
Syntax
Call up the command with the following parameters:
device mode { ap | client }
The parameters have the following meaning:
Parameters
ap
client
Result
The mode of the SCALANCE W700 device is specified.
Note
If you change the operating mode, the SCALANCE W700 devices needs to be restarted.
Before the device restarts, a prompt for confirmation is displayed. If you confirm the prompt,
the SCALANCE W700 device starts automatically in the new operating mode.
152
command to change to this mode.
wlan
Description
Mode: Access Point mode (default setting)
Mode: Client mode
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command, you return to the Global
exit
command, you return to the
end