Show Wlan Security Ap-Radius-Authenticator (Access Point) - Siemens SIMATIC NET Configuration Manual

Syntax
Call up the command with the following parameters:
show wlan security <wlan 0/X | vapX 0/Y> [context <Id (1-8)>]
The parameters have the following meaning:
Parameter
wlan 0/X
vapX 0/Y
context
Id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The settings are displayed.
10.2.1.2

show wlan security ap-radius-authenticator (Access Point)

Description
This command shows the settings of the RADIUS server.
Note
This command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameter assignment:
show wlan security ap-radius-authenticator
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
WLAN interface
Only available in client mode
VAP interface
Only available in Access Point mode
Keyword for a security context
Enter a valid security context ID.
or
cli#
Security and authentication
Range of values / note
Enter a valid interface.
Enter a valid interface.
-
Available only in client mode
1...8
10.2 WLAN
389