Wlan Mode (Access Point) - Siemens SIMATIC NET Configuration Manual

Network structures
6.1 WLAN
Using the
violate the permitted transmit power restrictions (
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan max tx-power <dBm(5-20)>
The parameter has the following meaning:
Parameters
dBm
Result
The transmit power is specified.
Further notes
You display the setting with the
6.1.5.50

wlan mode (access point)

Description
With this command, you specify the transmission standard.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
200
command, check whether or not the current WLAN settings
show wlan basic
Description
Transmit power in decibel-milliwatts (dBm)
show wlan basic <wlan 0/X>
TX Power Check
Range of values / note
5...20
Default: 20
command.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
) of the selected country.