No Smtp-Server - Siemens SIMATIC NET Configuration Manual

Network protocols
7.5 SMTP client
7.5.2.2

no smtp-server

Description
With this command, you delete an SMTP server entry.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
no smtp-server { ipv4 <ucast_addr> | fqdn-name <FQDN)>}
The parameters have the following meaning:
Parameter
ipv4
ucast_addr
fqdn-name
FQDN
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 25)".
Result
The SMTP server entry is deleted.
Further notes
You configure an SMTP server entry with the
356
Description
Keyword for an IPv4 address
IPv4 address of the SMTP server
Keyword for a domain name
Domain name (Fully Qualified Domain
Name)
smtp-server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Range of values / note
-
Enter a valid IPv4 unicast ad-
dress.
-
Maximum of 100 characters
command.
Configuration Manual, 10/2015, C79000-G8976-C351-05