Call up the command with the following parameter:
fault report ack <fault-state-id>
The parameter has the following meaning:
The message is acknowledged.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
With this command, you change to the EVENTS configuration mode.
You are in the Global configuration mode.
The command prompt is as follows:
Call the command without parameters:
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Range of values/note
ID of the mes-
Enter the ID of the message for the "Cold/Warm Start"
To obtain the ID, use the "
show events faults status
command to change to this mode.
command and are then in the