Show Mac-Address-Table Aging-Status; Commands In The Global Configuration Mode - Siemens SIMATIC NET Configuration Manual

Load control
8.1 Dynamic MAC aging
Syntax
Call the command without parameters:
show mac-address-table aging-time
Result
The time is displayed.
8.1.1.2

show mac-address-table aging-status

Description
This command shows whether or not MAC aging is enabled.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show mac-address-table aging-status
Result
The status of the MAC aging is displayed.
8.1.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
368
or
cli#
command to change to this mode.
configure terminal
or
end exit
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command and are then in the