Call up the command with the following parameters:
show wlan basic <wlan 0/X>
The parameter has the following meaning:
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
The following WLAN settings are displayed:
● Admin status (whether the interface is switched on or off)
● Frequency band
● WLAN mode
● DFS (802.11h)
● Outdoor Mode
● Max Tx Power
● TX power check: Indicates whether the current WLAN settings of the selected country
violate the permitted transmit power restrictions.
show wlan client (Client)
This command shows the client configuration of the SCALANCE W700 device, for example
how the MAC address is assigned to the client.
This command is only available in the client mode.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Range of values / note
Enter a valid interface.