wlan spectrumanalyzer start (Access Point)
With this command you start measurement with the spectrum analyzer. If you start a new
measurement, the previous measurement will be overwritten.
This command is available only in access point mode.
When the spectrum analyzer is started, all WLAN connections are terminated on both WLAN
interfaces. The access point then also does not send any beacons.
Do not enable the spectrum analyzer if the device is operating productively. This can
influence the performance of the device.
The functionality of the spectrum analyzer does not replace a dedicated spectrum analyzer.
● The WLAN interface is enabled.
● You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
Call the command without parameter assignment:
wlan spectrumanalyzer start
The measurement is started. The measured values are logged in a file.
You stop the recording with the
You display the settings of the spectrum analyzer with the
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
wlan spectrumanalyzer stop
Functions specific to SCALANCE
4.5 Spectrum analyzer
show wlan spectrumanalyzer