System time
5.2 NTP client
5.2.2.1
ntp
Description
With this command, you change to the Network Time Protocol (NTP).
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
ntp
Result
You are now in the NTP configuration mode.
The command prompt is as follows:
cli(config-ntp)#
Further notes
You exit the NTP configuration mode with the
5.2.3
Commands in the NTP configuration mode
This section describes commands that you can call up in the NTP configuration mode.
In the Global configuration mode, enter the
● If you exit the NTP configuration mode with the
configuration mode.
● If you exit the NTP configuration mode with the
EXEC mode.
120
or
command.
end
exit
command to change to this mode.
ntp
command, you return to the Global
exit
command, you return to the Privileged
end
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05