No Spanning-Tree Mst Hello-Time; Commands In The Mstp Configuration Mode - Siemens SIMATIC NET Configuration Manual

6.3.4.11

no spanning-tree mst hello-time

Description
With this command, you reset the hello time after which the bridge sends its configuration
BPDUs to the default value.
The default value is 2 seconds.
Requirement
You are in the interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no spanning-tree mst hello-time
Result
The setting for the hello time is reset to the default value.
Further notes
You can configure the setting for the hello time with the
command.
You display this setting and other information with the commands that start with
spanning tree ...
6.3.5

Commands in the MSTP configuration mode

This section describes commands that you can call up in the MSTP configuration mode.
In the Global configuration mode, enter the
change to this mode.
● If you exit the MSTP configuration mode with the
configuration mode.
● If you exit the MSTP configuration mode with the
Privileged EXEC mode.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
.
spanning-tree mst hello-time
spanning-tree mst configuration
command, you return to the Global
exit
command, you return to the
end
Network structures
6.3 Spanning Tree
show
command to
275