Vlan; The "Show" Commands; Show Dot1D Mac-Address-Table - Siemens SIMATIC NET Configuration Manual

6.2

VLAN

This section describes commands for configuring and managing virtual networks (VLANs).
6.2.1

The "show" commands

This section describes commands with which you display various settings.
With the command
configuration mode.
To do this, you replace
Example
do show cli-console-timeout
6.2.1.1

show dot1d mac-address-table

Description
This command shows the table with the static and dynamic unicast entries and the dynamic
multicast entries.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call up the command with the following parameters:
show dot1d mac-address-table [address <aa:aa:aa:aa:aa:aa>]
The parameters have the following meaning:
Parameter
address
aa:aa:aa:aa:aa:aa
interface
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
do [command]
[command]
[interface {<interface-type> <interface-id>}]
Description
Keyword for a MAC address
MAC address
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
you can execute the "show" commands in every
with the "show" command that you want to execute.
Network structures
6.2 VLAN
Range of values/note
-
Specify a valid MAC ad-
dress.
-
Enter a valid interface.
217