Dhcp Server; The "Show" Commands - Siemens SIMATIC NET Configuration Manual

The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip dhcp client mode {mac|client-id<client-id>|sysname}
The parameters have the following meaning:
Parameter
mac
client-id
client-id
sysname
Result
The registration mode of the DHCP client is configured.
7.3

DHCP server

This section describes commands relevant for configuring the DHCP server.
Requirement
The connected devices are configured so that they obtain the IPv4 address from a DHCP
server.
7.3.1

The "show" commands

This section describes commands with which you display various settings.
With the command
configuration mode.
To do this, you replace
Example
do show cli-console-timeout
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
The client registers with its MAC address
The client registers with the assigned ID
Name of the assigned ID
The client registers with the assigned system
name
you can execute the "show" commands in every
do [command]
with the "show" command that you want to execute.
[command]
Network protocols
7.3 DHCP server
Range of values / note
-
-
max. 32 characters
-
303