Ip Dhcp-Server Pool - Siemens SIMATIC NET Configuration Manual

Industrial wireless lan to ieee 802.11n command line interface
Hide thumbs Also See for SIMATIC NET:
Table of Contents

Advertisement

Network protocols
7.3 DHCP server
7.3.2.5

ip dhcp-server pool

Note
The command is only available with the following device:
• SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
• SCALANCE W761-1 RJ45 in access point mode (article number): 6GK5761-1FC00-0AA0
and 6GK5761-1FC00-0AB0 (US version))
Description
With this command, you have three options of changing to the DHCPPOOL configuration
mode and to assign an interface to the IPv4 address band.
1. If you call the
with the next free pool ID is created and you change directly to the corresponding
DHCPPOOL configuration mode.
You then configure the interface and the other settings in the DHCPPOOL configuration
mode.
2. If you call the command
change to the corresponding DHCPPOOL configuration mode.
3. If you call the command
you call a variant of the command. With this variant, you assign an interface to the IPv4
address band and change to the DHCPPOOL configuration mode. If the ID of the
address IPv4 address band does not yet exist, it will be created. You then configure the
other settings in the DHCPPOOL configuration mode.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip dhcp-server pool { <pool-id (1-5)> | show-interface-options }
The parameters have the following meaning:
Parameter
pool-id
show-interface-options
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
310
command without parameters, and IPv4 address band
ip dhcp-server pool
ip dhcp-server pool
ip dhcp-server pool
Description
ID of the addressed IPv4
address band
Displays the possible
options for the interface.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
with the parameter
pool-id (1-5)
with the parameter
show-interface-options
Range of values / note
1 ... 5
Only ID = 1 is supported.
-
Configuration Manual, 10/2015, C79000-G8976-C351-05
, you
,

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Scalance w720Scalance w760

Table of Contents