No Ip Address - Siemens SIMATIC NET Configuration Manual

Network protocols
7.1 IPv4 protocol
Result
The IP address is assigned to the VLAN interface.
Note
Effectiveness of the command
The command is effective immediately.
If you configure the interface via which you access the device, the connection will be lost!
Further notes
You delete the settings with the
You display this setting and other information with the
7.1.3.2

no ip address

Description
With this command, you delete the assignment of an IP address to a VLAN interface.
Requirement
You are in the Interface configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call up the command with the following parameters:
no ip address [{ <ucast_addr>}]
The parameter has the following meaning:
Parameter
ucast_addr
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
296
no ip address
Description
IP Address of the VLAN interface that will
be deleted
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
command.
show ip interface
Range of values / note
enter a valid IP address
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.