Show Spanning-Tree Active - Siemens SIMATIC NET Configuration Manual

Network structures
6.3 Spanning Tree
Syntax
Call up the command with the following parameters:
show spanning-tree [{summary|blockedports|pathcost method}]
The parameters have the following meaning:
Parameter
summary
blockedports
pathcost method
Result
The settings for the spanning tree function are displayed.
Further notes
You can show further settings for special aspects of the Spanning Tree Protocol with the
following commands:
●

show spanning-tree active

●
show spanning-tree bridge
●
show spanning-tree detail
●
show spanning-tree interface
●
show spanning-tree root
●
show spanning-tree mst
6.3.1.2 show spanning-tree active
Description
This command shows the settings for the active ports of the spanning tree function.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
242
Description
Shows a summary
Shows the blocked ports
Shows whether 16-bit (short) or 32 bit (long) values are used in the calcula-
tion
or
cli#
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05