Commands In The Global Configuration Mode; Ip Dhcp Config-File-Request - Siemens SIMATIC NET Configuration Manual

Result
The IP address is assigned again.
This address can be a different address from the previously assigned address.
Further notes
You can display the statistical information of the DHCP client with the
stats
You show the statistical information and the configuration of the IP interface with the
interface
7.2.3

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
7.2.3.1

ip dhcp config-file-request

Description
If the DHCP config file request option is set, the device requests the TFTP address and the
name of a configuration file from the DHCP server. If the device is restarted following the
completed download, the configuration settings are read from this file.
With this command, you enable the DHCP config file request option.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
ip dhcp config-file-request
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.
command.
command to change to this mode.
configure terminal
or
end exit
Network protocols
7.2 DHCP client
show ip dhcp client
command and are then in the
show ip
301