Show Interface Memory - Allied Telesis AR2050V Command Reference Manual

S C M
YSTEM ONFIGURATION AND

SHOW INTERFACE MEMORY

show interface memory
Overview This command displays the shared memory used by either all interfaces, or the
specified interface or interfaces. The output is useful for diagnostic purposes by
Allied Telesis authorized service personnel.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and Configuration
show interface memory
Syntax
show interface <port-list> memory
Mode User Exec and Privileged Exec
Example To display the shared memory used by all interfaces, use the command:
awplus#
To display the shared memory used by port1.0.1 and port1.0.5 to port1.0.6, use the
command:
awplus#
Output Figure 6-5:
C613-50186-01 Rev B
C
ONITORING OMMANDS
Parameter Description
<port-list>
Display information about only the specified port or ports. The port
list can be:
• an Eth (e.g. eth1) or switch port (e.g. port1.0.4), a static channel
group (e.g. sa2) or a dynamic (LACP) channel group (e.g. po2)
• a continuous range of ports separated by a hyphen (e.g.
port1.0.1-1.0.4, or sa1-2, or po1-2)
• a comma-separated list of ports and port ranges (e.g.
port1.0.1,port1.0.4-1.0.6). Do not mix port types in the same list.
show interface memory
show interface port1.0.1,port1.0.5-1.0.6 memory
Example output from the show interface memory command
awplus#show interface memory
Vlan blocking state shared memory usage
---------------------------------------------
Interface shmid
port1.0.1 294921
port1.0.2 491535
port1.0.3 458766
port1.0.4 524304
port1.0.5 425997
port1.0.6 589842
port1.0.7 557073
port1.0.8 622611
eth2 327690
eth1 393228
lo 360459
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Bytes Used nattch
512 1
512 1
512 1
512 1
512 1
512 1
512 1
512 1
512 1
512 1
512 1
"Getting Started
Guide.
Status
242