Output Parameters (Control Flow Normal) - Omron FH-3 Series Reference Manual

3
In the "Timeout" area, specify a value for each item.
Setting item
Use timeout
Setting time
Unit judgement in timeout
Important
• Normally the "Use timeout" check box should be selected. When the check mark is removed from "Use timeout",
the wait state can only be cleared by executing a "Wait state clear command" from an external device.

Output Parameters (Control Flow Normal)

You can set this item to change the output parameters.
The output parameters are the conditions and parameters for outputting measurement results to other
processing units or external devices. Normally, the factory default values can be used.
1
Click [Output parameter] in the Item Tab area.
2
Specify a value for each item.
Setting item
Reflect to the overall
judgement
FH/FZ5 Processing Item Function Reference Manual
Setting value
[Factory default]
• [Checked]
• Unchecked
0 to 120,000
[5,000]
• [NG]
• OK
Setting value
[Factory default]
• [ON] Set whether the judgement result from this processing unit is
• OFF applied to the overall scene judgement.
Description
If you want to clear the measurement flow wait state
after a certain period of time elapses, select the "Use
timeout" check box.
This should normally be used with the check box
selected.
This item can be set when the [Use timeout] check box
is selected.
Set the time in ms after which the wait state on the
processing unit is cleared.
When a timeout is used, the wait state is cleared when
the time set in "Setting time" elapses after the
measurement unit starts measurement processing.
When the wait state is cleared, the measurement flow
resumes.
This item can be set when the [Use timeout] check box
is selected.
Select whether the judgement result of the processing
unit is NG or OK when the processing unit times out
after the "Setting time" in measurement processing.
Description
843
Control Flow Normal
5