Settings Flow (Fine Matching) - Omron FH-3 Series Reference Manual

Settings Flow (Fine Matching)

Set up fine matching in the follow steps.
Necessary Steps
Start
Model Registration (Fine Matching)
Measurement Parameters (Fine Matching)
Settings completed
Test measurement
List of Fine Matching Items
Item name
This item registers the pattern characteristic of the measurement image as a model.
Model parameter values can be changed as needed to address unstable measurement results or to
Model register
increase the processing speed. Normally, the factory default value will be used.
Reference:
Modify this setting as necessary when defects cannot be detected successfully. This sets the reference
grayscale used when calculating differences between the model and the inspected object image.
Diff. image disp.
Normally, the factory default value will be used.
Reference:
This item specifies the judgement condition for measurement results. Specify the criteria to judge the
measurement result if the X and Y coordinates and the correlation values with the model are OK.
Measurement Measurement parameters can be changed as needed to address unstable measurement results or to
increase the processing speed.
Reference:
This item can be changed if necessary. Normally, the factory default value will be used.
Output
Use the output parameter to specify how to handle the coordinates.
parameter
Reference:
380
Fine Matching
Optional Steps
Diff. Image Disp. (Fine Matching)
Output Parameters (Fine Matching)
Model Registration (Fine Matching) (p.381)
Difference Image Display (Fine Matching) (p.383)
Measurement Parameters (Fine Matching) (p.385)
Output Parameters (Fine Matching) (p.387)
Verify/Adjust results
Description
FH/FZ5 Processing Item Function Reference Manual