Settings Flow (Scan Edge Position) - Omron FH-3 Series Reference Manual

Settings Flow (Scan Edge Position)

Set the scan edge position with the following steps.
Necessary Steps
Start
Region Setting (scan edge position)
Judgement Conditions (scan edge position)
Settings completed
Test measurement
Item List for Scan Edge Position
Item name
Region setting
Edge color
(for color cameras only)
Ref. setting
Measurement
Judgement
Output parameter
244
Scan Edge Position
This item is used to set up the measurement area.
Reference: Region Setting (Scan Edge Position) (p.245)
If the color of the edges to be detected is decided, specify the information for the edge color to be
detected.
Reference: Edge Color Specification - For Color Cameras Only (Scan Edge Position) (p.246)
This item can be changed if necessary.
The edge position measured once is registered when the region is set.
Reference: Reference Setting (Scan Edge Position) (p.247)
This item changes the measurement parameter as necessary when the measurement result is
unstable.
The displayed items depend on whether your camera is a color or monochrome camera. Normally,
the factory default value will be used.
Reference: Measurement Parameters (Scan Edge Positions) (p.248)
This item specifies the judgement condition for measurement results.
Reference: Judgement Conditions (Scan Edge Position) (p.251)
This item can be changed if necessary. Normally, the factory default value may be used.
Select the measurement result coordinates and set how to handle the coordinates.
Reference: Output Parameters (Scan Edge Position) (p.252)
Optional Steps
Edge Color Specification – For Color
Cameras Only (scan edge position)
Reference Setting (scan edge position)
Measurement Parameters (scan edge position)
Output Parameters (scan edge position)
Verify/Adjust results
Description
FH/FZ5 Processing Item Function Reference Manual