Output Parameters (Scan Edge Position) - Omron FH-3 Series Reference Manual

Setting item
Long distance Max. 0 to 99999.9999
Long distance Min.
Short distance Max. 0 to 99999.9999
Short distance Min. 0 to 99999.9999
Deviation
Line angle
Lost point count
Note
• Judgement condition of the straight line's inclination
To set 90° ±10° (80° to 90°, -80° to -90°) range as OK, set the judgement condition to 80° to 100°.
The range of straight line's inclination is -89.999° to 90° Internally, the angle X of -90° to 0° is the same value as X +
180°, the angle X of 90 to 180° is the same value as X - 180°.
180°
Upper limit value 100°

Output Parameters (Scan Edge Position)

Specify how to treat the coordinates to be output to the external device as measurement results. This item can
be changed if necessary. Normally, the factory default value will be used.
Important
• After setting up the measurement parameters, changing the output parameters will cause measurement results to vary
accordingly. If the output parameters have been changed, re-specify the measurement, too.
1
Click [Output parameter] in the Item Tab area.
252
Scan Edge Position
Set value
0 to 99999.9999
0 to 99999.9999
-180 to 180
0 to 100
Inspection area
Lower limit value 80°
OK range ±10°
Straight line's inclination 90°
Description
Specify the upper and lower limits of the long distance
maximum judged to be OK.
Specify the upper and lower limits of the long distance
minimum judged to be OK.
Specify the upper and lower limits of the short distance
maximum judged to be OK.
Specify the upper and lower limits of the short distance
minimum judged to be OK.
Specify the upper and lower limits of the deviation judged
to be OK.
Specify the upper and lower limits of the line angle judged
to be OK.
Specify the upper and lower limits of the lost point count
judged to be OK.
- direction
0°
+ direction
FH/FZ5 Processing Item Function Reference Manual