Omron FH-3 Series Reference Manual page 328

Setting item
Fill profile
3
If necessary, in the "Display setting" area, set up display settings for the images displayed in
the Image Display area.
4
When the setting has been changed,
click [Measurement] in the "Detail" area
to verify whether measurements can be
made correctly.
5
Set up the judgement condition.
Note
• The values beside each item are measurement results of the displayed image. Take these values into
consideration to determine the upper and lower limits.
Setting item
Area
Gravity X
Gravity Y
326
Gravity and Area
Set value
[Factory default]
[None] The empty section in the center is not filled in.
In the measurement region, the part between the extracted-color start
point and end point in the X-axis direction is measured as having the
extracted color. Since filling is applied only to the X-axis direction, the
processing is faster than filling up holes.
Input image
Fill outline
The part surrounded by the extracted color, like a doughnut hole, is filled
with the extracted color.
Input image
Filling up holes
Set value
0 to 999999999.9999
-99999.9999 to 99999.9999
-99999.9999 to 99999.9999
Description
Fill profile image
Image after filling up hole
Description
Specify the area to be judged as OK.
Specify the range of X-axis shifting that is judged to be
OK.
Specify the range of Y-axis shifting that is judged to be
OK.
FH/FZ5 Processing Item Function Reference Manual