Omron FH-3 Series Reference Manual page 733

3
Select [Lefthand] or [Righthand] in
[Coordinate].
Camera position is Z-axis respects to the
surface where put on the work piece including
movement axis.
[Lefthand]: Clockwise from camera vision.
[Righthand]: Counterclockwise from camera
vision.
4
Clicking [...] in [Y-axis relative angle(X-axis standard)], set relative angle of X-axis.
Set an angle configured X-axis and virtually-calculated Y-axis. The orthogonal coordinate is
normaly 90°.
5
Clicking [...] in [Y-axis relative angle(X-axis standard)], set relative angle of X-axis.
Set an angle configured X-axis and virtually-calculated Y-axis. The orthogonal coordinate is
normaly 90°.
6
Clicking [...] in [X-axis limit], set both upper and lower limit of movement axis (X-axis).
Setting Item
[Factory default]
• [X-axis]
Movement axis
• Y-axis
• [Lefthand]
Coordinate
• Righthand
Y-axis relative
0.000001 to
angle
180.000000
(X-axis
[90.000000]
*1
standard)
Y-axis relative
angle 0.100000 to
magnification 9.999999
(X-axis [1.000000]
*2
standard)
-99999.9999 to
99999.9999
*3
X-axis limit
[-99999.9999] to
[99999.9999]
*1, *2, *3: Those function name are displayed on the screen. If you select Y-axis in Movement axis, those name will change
as below.
*1 Y-axis relative angle (X-axis standard)
Y-axis relative angle magnification (X-axis
*2
standard)
*3 X-axis limit
FH/FZ5 Processing Item Function Reference Manual
Setting value
This parameter is for selecting type of Stage.
When you select X-axis, set as X Stage.
When you select Y-axis, set as Y Stage.
Set coordinate.
[Lefthand]: Clockwise from camera vision.
[Righthand]: Counterclockwise from camera vision.
When you select X-axis as Movement axis, set an angle virtually-calculated
of Y-axis.
When you select Y-axis as Movement axis, set an angle virtually-calculated
of X-axis.
When you select X-axis as Movement axis, set a relative angle virtually-
calculated of Y-axis.
When you select Y-axis as Movement axis, set a relative angle virtually-
calculated of X-axis.
When you select X-axis as Movement axis, set upper and lower limit of X-
axis.
When you select Y-axis as Movement axis, set upper and lower limit of Y-
axis.
Unit is a coordinate set in calibration function.
Select X-axis as Measurement axis
Lefthand
Camera
Z+
X+
X stage
Y+
Description
Select Y-axis as Measurement axis
X-axis relative angle (Y-axis standard)
X-axis relative angle magnification (Y-axis
standard)
Y-axis limit
Righthand
Camera
Z+
Y+
X+
X stage
*1
*2
*3
731
Stage Data
4