Color Gray Filter
This processing item converts a color image input from a color camera into a monochrome image.
The available filters are "Primary color filter (RGB)", "Complementary color filter (CMY)", "Brightness filter", and "HSV filter".
This processing item cannot be used with monochrome images. Such use causes a judgement of NG (incompatible image).
Note
• The processing items after Color Gray Filter are the same as when a monochrome camera is connected.
Used in the Following Case
• To convert a color image to a monochrome image with a specific color enhanced
Example) To obtain a monochrome image with the dark red area enhanced
Important
• Processing is different for color images and monochrome images. If the camera type, color camera, or monochrome
camera, was changed from a previous setup, a reset of some settings may be needed.
Filter Setting (Color Gray Filter)
This item sets the filter.
1
In the Item Tab area, click [Filter Setting].
2
In the "Display mode" area, click [Change display] to switch between camera image types.
The displayed contents of the Image Display area will be switched.
Setting item
Display mode
3
Select the type of filter in the "Filter
type" area.
Setting item
Filter type
524
Color Gray Filter
Set value
[Factory default]
Through image display The latest image is always input from the camera and displayed.
The image that was scanned in the immediately preceding
[Freeze image display]
measurement is displayed.
Set value
[Factory default]
[RGB filter]
Specify the color extraction range with R, G, and B.
HSV filter
Specify the color extraction range with hue and color chroma.
Description
Description
FH/FZ5 Processing Item Function Reference Manual