Omron FH-3 Series Reference Manual page 241

3
If necessary, set each item in the "Noise removal" area.
Setting item
Noise level
Noise width
4
When the setting has been changed,
click [Measurement] in the "Detail" area
to verify whether measurements can be
made correctly.
5
Set up the judgement condition.
Setting item
Edges
Pitch
Ave pitch
Width
Ave width
6
If a circumference with a width or an arc with a width is set for the region, set the profile
display settings as required.
Setting item
Enlarged display
FH/FZ5 Processing Item Function Reference Manual
Set value
[Factory default]
When detection is affected by noise, increase this value.
0 to 442
Reference: "Appendixes Measurement Mechanism Noise Level" in the
[5]
"Vision System FH/FZ5 Series User's Manual (Z365)"
Set the width for judging noise.
0 to 9999 When detection is affected by noise, increase this value.
Reference: "Appendixes Measurement Mechanism Noise Width" in
[0]
the "Vision System FH/FZ5 Series User's Manual (Z365)"
Set value
0 to 999
0 to 99999.9999
0 to 99999.9999
0 to 99999.9999
(Distance between two
central points)
0 to 99999.9999
Set value
[Factory default]
[Not Visible] If you place a check here, the profile will be displayed for the length along
the circumference of the circumference with a width or arc with a width.
Visible
Use an enlarged display to check the details of the profile.
Description
Description
Specify a range to be judged as OK.
Pitch Width
Number
Description
2
239
Edge Pitch