Ec Corner; Settings Flow (Ec Corner) - Omron FH-3 Series Reference Manual

Ec Corner

This processing item measures a corner position (corner) of a work.
The intersection of two lines generated from the edge information of two sides of a square work is measured.
A desired corner can be measured by setting the length, direction, edge intensity and other conditions.
Used in the Following Case
• When you want to align the work position based on the feature of its corner
Important
• Processing is different for color images and monochrome images. If the camera type, color camera, or monochrome
camera, was changed from a previous setup, a reset of some settings may be needed.

Settings Flow (Ec Corner)

Set up EC corner according to the following steps.
Make sure to set
Start
Region Setting (Ec Corner)
Line Extraction (Ec Corner)
Corner Extraction (Ec Corner)
Measurement Parameters (Ec Corner)
Settings complete
Test measurement
190

Ec Corner

Set as necessary.
Reference Setting (Ec Corner)
Output Parameters (Ec Corner)
Check results/make adjustments
FH/FZ5 Processing Item Function Reference Manual