Omron FH-3 Series Reference Manual page 184

Confirm the measurement result on the display (Display setting)
1
Set the check box in the Display setting area.
2
Confirm the measurement processing condition, then set Measurement condition.
Setting item
Display edge
image
Display corresponding
model
Set Judgment condition
Set the upper and lower values to judge the measurement result. When the measurement result value is within
the upper and lower value, Judgment is [OK] (pass). When the measurement result value exceeds either the
upper, or lower value Judgment is [NG] (failed). About The Judgment result for the Processing Unit is [OK] when
the judgment for all measurements is [OK], however it will be [NG] if any measurement result is [NG].
1
Set the value in the Judgment area.
Setting item
Count
Measure X
Measure Y
Search angle
Correlation
Note
• Measurement result will be displayed on the right of the Judgment items. You can set the Judgment condition
refer to this value.
182
Shape Search III
Setting value
[Factory default]
• Checked
• [Unchecked]
• Checked
• [Unchecked]
Setting value
[Factory default]
0 to 128
[0] to [32]
-99999.9999 to 99999.9999
[-99999.9999] to [99999.9999]
-99999.9999 to 99999.9999
[-99999.9999] to [99999.9999]
-180 to 180
[-180] to [180]
0 to 100
[60] to [100]
Description
Check this item when you confirm extracted edge set in
[Edge level] on the display.
Check this item when you confirm detected Model on the
display.
Description
Set the upper and lower values of number of detected
Model.
Set the upper and lower values of detected Model on X
coordinate.
Set the upper and lower values of detected Model on Y
coordinate.
Set the upper and lower values of detected Model angle.
Set the upper and lower correlation values of detected
Model.
Judgment will be [NG] instead of the lower value when the
measurement result correlation is zero.
FH/FZ5 Processing Item Function Reference Manual