Measurement Parameters (Shape Search Ii) - Omron FH-3 Series Reference Manual

Referencing a unit
Set a reference by referencing a detection point unit with registered X coordinate, Y coordinate and angle data.
1
In the Item Tab area, click [Ref. setting].
In the display area, the current reference position will be displayed as the crosshair cursor.
2
In the "Method" area, select "Unit".
3
In the scene in the "Unit" area, select a
detection point unit.
4
Perform the next measurement, and the reference will be displayed.

Measurement Parameters (Shape Search II)

Specify the search measurement conditions and the judgement conditions for the measurement results.
1
In the Item Tab area, click [Measurement].
2
In the "Measurement condition" area,
specify a value for each parameter.
Setting item
Candidate LV
High-Prec.
Rotation
Angle range
When executing a multi search
Setting item
Multiple output
Count
162
Shape Search II
Set value
[Factory default]
0 to 100 Specify the threshold value with which to detect candidate points in a rough
[50] search. Specify a smaller value when the detection is unstable.
• Checked "High-Prec" mode enables sub-pixel and sub-degree order position and pose
• [Unchecked] estimation. There is just a slight increase of processing time.
• [Checked] Select the parameter when the target may be rotated and set appropriate
• Unchecked range in "Angle range".
-180 to 180
Specify the angle range when "Rotation" is checked.
[-180] to [180]
Set value
[Factory default]
• [Checked]
• Unchecked
1 to 32
[32]
Description
Description
Check this parameter enables multiple target detection.
Specify the maximum number of detections.
FH/FZ5 Processing Item Function Reference Manual