Settings Flow (Shape Search Iii) - Omron FH-3 Series Reference Manual

Settings Flow (Shape Search III)

Set up shape search III according to the following steps.
Make sure to set
Start
Model (Shape Search III)
Region Setting (Shape Search III)
Measurement (Shape Search III)
Settings complete
Test measurement
List of Shape Search III Items
Item name
This item registers the pattern characteristic of the measurement image as a model.
Model It changes the model parameter as necessary.
Reference: Model (Shape Search III) (p.170)
This item is used to set up the measurement area.
Instead of measuring the entire input image, narrowing the measurement area shortens the processing
Region setting
time.
Reference: Region Setting (Shape Search III) (p.176)
This item can be changed if necessary. It sets a position in the model that should be used as the detection
coordinates during measurement. Usually, the central position of the set model is registered as the
Detection point
detection coordinates.
Reference: Detection Point (Shape Search III) (p.177)
This item can be changed if necessary. It sets the reference position within the camera's field of view.
Ref. setting
Reference: Reference Setting (Shape Search III) (p.178)
This item specifies the judgement condition for measurement results. Specify the criteria to judge the
Measurement
measurement result if the X and Y coordinates and the correlation values with the model are OK.
parameter
Reference: Measurement parameter (Shape Search III) (p.179)
This item can be changed if necessary. Normally, the factory default value will be used.
Output
Use the output parameter to specify how to handle the coordinates.
parameter
Reference: Output Parameter (Shape Search III) (p.183)
FH/FZ5 Processing Item Function Reference Manual
Set as necessary.
Detection Point (Shape Search III)
Reference Setting (Shape Search III)
Output parameters (Shape Search III)
Check results/make adjustments
Description
2
169
Shape Search III