Omron FH-3 Series Reference Manual page 137

Changing Model Parameters
Model parameter values can be changed as needed to address unstable measurement results or to increase the
processing speed. Normally, the factory default value will be used.
After changing a setting, check whether measurement can be done properly by performing an actual
measurement.
1
In the "Model parameter" area, specify a
value for each item.
Setting item
Rotation
Upper limit
value
Angle range
Lower limit
value
Skipping angle
Reverse
Size change
2
When the "Size change" option is
checked, click [Detail setting].
The "Model parameter: Size change" area is
displayed.
Setting item
[Factory default]
• [XY]
Move axis • X
• Y
50 to 150
Move range
[90,110]
1 to 99
Skipping width
[10]
3
Click [Return].
The "Model parameter" area is displayed.
FH/FZ5 Processing Item Function Reference Manual
Set value
[Factory default]
• Checked
When the measurement object is rotating, select the "Rotation"
• [Unchecked]
check box and specify how many degrees the model created
-180 to [180] rotates each time and through what range of angles. A smaller
skipping angle increases stability, but slows down the processing.
The normal direction is clockwise.
[-180] to 180
1 to 30 Specify how many degrees the model created rotates each time. A
[5] smaller angle increases stability, but slows down the processing.
• Checked
Specify whether to allow the reverse of light and dark for the model.
• [Unchecked]
Specify whether to allow size change for the model.
• Checked
When checked, click [Detail setting] and specify a value for each
• [Unchecked]
item.
Set value
Specify the model variable direction.
Specify the range in which to change the model size.
Specify the skipping percentage within the move range by which to change
models being created. A smaller skipping width increases precision, but
slows down the processing.
Description
Description
2
135
ECM Search