Omron FH-3 Series Reference Manual page 38

• With external power supply
0ch (spot lighting) not connected
Total power
consumption
Greater than 15 W
Greater than
15 W or less
15 W
7.5 W or less
Less than 15 W
15 W or less
7.5 W or less
7.5 W or less Less than 7.5 W
0ch (spot lighting) connected
Total power
consumption
Greater than 15 W
Greater than
15 W or less
14 W
7.5 W or less
Less than 14 W
14 W or less
7.5 W or less
5.5 W or less Less than 5.5 W
*1: Lighting modes
Always-on
lighting mode
Simultaneous
lighting mode
Single
lighting mode
*2: Turning OFF the READY signal is delayed in comparison with not connecting a camera with lighting controller by
approximately the exposure time.
Example: Connection example for connecting an external power supply and the lighting modes
• If four lights with a power consumption of 1 W each are connected to a camera with lighting controller,
always-on lighting, simultaneous lighting, and single lighting are all possible.
• If four lights with power consumptions of 2 W, 3 W, 4 W, and 5 W are connected to a camera with lighting
controller, simultaneous lighting and single lighting are possible.
• If four lights with power consumptions of 12 W, 1 W, 2 W, and 1 W are connected to a camera with lighting
controller, only single lighting is possible.
36
Camera Image Input
Power consumption
Connectability
per channel
Not connectable
Connectable
Connectable
Connectable
Connectable
Connectable
Power consumption
Connectability
per channel
Not connectable
Connectable
Connectable
Connectable
Connectable
Connectable
In this mode, the lights are always turned ON for a specific pulse cycle. The always-on lighting mode is
used if you place a check in "On all the time" in the "Lighting control" area.
In this mode, all of the connected lights are turned ON in synchronization with the trigger. Set the
"Adjustment" set values in the "Lighting control" area for each light to any value other than 0 for all of
the parts.
In this mode, only one of the connected lights is turned ON in synchronization with the trigger. Set the
"Adjustment" set value in the "Lighting control" area to any value other than 0 for the part for only one
channel. The lights will not turn ON if you set two or more channels to an adjustment other than 0.
Lighting mode
Always-on Simultaneous
lighting mode lighting mode
--- ---
NA NA
NA NA
NA OK
NA OK
OK OK
Lighting mode
Always-on Simultaneous
lighting mode lighting mode
--- ---
NA NA
NA NA
NA OK
NA OK
OK OK
FH/FZ5 Processing Item Function Reference Manual
*1
READY OFF
Single lighting
time delay
mode
--- ---
OK Yes
OK None
OK Yes
OK Yes
OK None
*1
READY OFF
Single lighting
time delay
mode
--- ---
OK Yes
OK None
OK Yes
OK Yes
OK None
*2
*2