Measurement Parameter (Shape Search Iii) - Omron FH-3 Series Reference Manual

Updating the reference coordinate by measuring the displayed image (reference measurement)
Measure the image displayed on the setting window and use the measurement result as the reference
coordinate.
1
When you want to update the reference angle besides the reference point, select the [Update
the angle when measure ref.] check box.
2
Click [Measure ref.].
The reference coordinate will be updated.
3
If you want to use the reference coordinate as the coordinate before the position
compensation, select the [Use point coordinate before scroll] check box.
Note
• When using the Position Compensation processing item, the coordinates after position compensation will be the
reference point. When the coordinates before the position compensation is needed for alignment, etc., select the
[Use point coordinate before scroll] check box.
Set the reference point by referencing processing unit (Unit)
Set the reference point by referencing the Detection Point processing unit set in the measurement flow. In this
method, the position and angle are set based on measurement results, and thus they are more accurately set
than the Numerical setting method.
1
Click the Ref. setting tab.
2
In the [Method] area, select [Unit].
3
In the [Unit] area, select the Detection
Point processing unit in the current
Scene.
4
Perform the next measurement, and then the reference point will be applied.

Measurement parameter (Shape Search III)

Set the measurement conditions or judgment condition in this Measurement parameter.
FH/FZ5 Processing Item Function Reference Manual
2
179
Shape Search III