Omron FH-3 Series Reference Manual page 388

Item
Sort condition
Label area
3
When the setting has been changed,
click [Measurement] in the Detail area to
verify whether measurements can be
made correctly.
4
Set up the judgement condition.
Setting item
Quantity
Area
386
Fine Matching
Set value
[Factory default]
Specify the conditions by which label number is re-assigned.
When sorting referencing the X and Y coordinates, the upper left is the origin. This will not
affect the coordinate systems set up through the [Camera Image Input] calibration.
X
0
Y
Area ascending
[Area descending]
X ascending
X descending
Y ascending
Y descending
[0] to [999999999]
Set value
0 to 9999
0 to 999999999.9999
Number re-assigning begins from the labels with smaller areas.
2
1
0
Number re-assigning begins from labels with larger area.
Number re-assigning begins from the label with a smaller gravity X
coordinate.
0 1 2
Number re-assigning begins from the label with a larger gravity X
coordinate.
Number re-assigning begins from the label with a smaller gravity Y
coordinate.
0
1
2
Number re-assigning begins from the label with a larger gravity Y
coordinate.
Specify the range of the area to be judged as a label.
Specify the range of the number of labels that is judged to be
OK.
When "Binary area" is used, the white pixels as a whole will be
regarded as one label.
Specify the range of the area that is judged to be OK.
When the "Labeling" is used, the area of the label number will
be specified instead.
FH/FZ5 Processing Item Function Reference Manual
Description
Description