Judgement Conditions (Scan Edge Position) - Omron FH-3 Series Reference Manual

5
In the "Approximate line" area, specify
the point to be used for the calculation of
approximate lines.
Setting item
Noise cancel
Extraction rate

Judgement Conditions (Scan Edge Position)

Specify the range to be judged as OK.
Short (Concave) distance
Bottom edge position
1
In the Item Tab area, click [Judgement].
2
Set up the judgement condition.
Note
• The values beside each item are measurement results of the displayed image. Take these values into
consideration to determine the upper and lower limits.
Setting item
Peak edge position
X
Peak edge position
Y
Bottom edge
position X
Bottom edge
position Y
Edge position X
Ave.
Edge position Y
Ave.
FH/FZ5 Processing Item Function Reference Manual
Set value
[Factory default]
• ON When a check is placed at [ON], an approximate line is found by
• [OFF] excluding the points with large deviation among the measured points.
Set the ratio of measurement points used for approximate straight line
calculation to all measurement points.
0 to 100 When there is considerable noise, reducing this value enables calculation
[50] of an approximate straight line with many of the noise points removed.
When there is little noise, increasing this value enables calculation of a
high-accuracy straight line using many measurement points.
Approximate line
Peak edge position
Line angle
Long (Convex) distance
Set value
-99999.9999 to 99999.9999
-99999.9999 to 99999.9999
-99999.9999 to 99999.9999
-99999.9999 to 99999.9999
-99999.9999 to 99999.9999
-99999.9999 to 99999.9999
Description
Description
Specify the X-axis upper and lower limits of the peak
edge position X judged to be OK.
Specify the Y-axis upper and lower limits of the peak edge
position Y judged to be OK.
Specify the X-axis upper and lower limits of the bottom
edge position X judged to be OK.
Specify the Y-axis upper and lower limits of the bottom
edge position Y judged to be OK.
Specify the X-axis upper and lower limits of the average
edge position judged to be OK.
Specify the Y-axis upper and lower limits of the average
edge position judged to be OK.
251
Scan Edge Position
2