Omron FH-3 Series Reference Manual page 286

Setting item
Scan sub-region
Start angle
Important
• When the width measurement target is set to "Diameter" and the number of divisions and the skipping angle are
set to an odd number value, 1 will be added to these settings so that they become even numbers.
The region is divided by the specified number of points.
5
Specify the filtering settings as
necessary.
Setting item
Mask size
6
Perform the display setting if required.
Placing a check at [Filtered image] makes it
easier to change the filtering setting.
Setting item
Filtered image
284
Circular Scan Edge Width
Set value
[Factory default]
3 to 360
Divide number
[4]
When the width measure
type is circumference
1.000 to 179.999
Angle number When the width measure
type is diameter
1.000 to 90.000
[90.000]
0 to 359
[0]
Set value
[Factory default]
0 to 1000
[10]
Set value
[Factory default]
• [Unchecked]
• Checked
Set the measurement point.
Use either the "Divide num" or the "Divide angle" for this
setting.
Set the number of divisions for the circle.
The specified value is used as the measurement point.
Set the skipping angle for the circle.
The measurement point is determined based on the
specified angle.
Set the start angle to specify a region.
Explanations of the display
• Green solid line:
Represents the circular region.
• Rectangle:
Represents the sub-region.
• Pink solid line:
Represents the angle and the measurement direction (arrow)
to specify the region.
Set the filter size when smoothing the measurement point vicinity. When 5
is set, smoothing is processed for a total of 11 points: the measurement
point and the 5 pixels before and after it.
If checked, the filtered image of the ranges set with the Scan sub-region
and Filter size after smoothing is displayed.
FH/FZ5 Processing Item Function Reference Manual
Description
Description
Description