Model Registration (Ecm Search) - Omron FH-3 Series Reference Manual

Model Registration (ECM Search)

Register the pattern characteristic of the measurement object as a model. In an ECM search, only the image
profile information is registered.
Important
• For ECM search, 6 pixels at each end of an image cannot be registered as a part of the model.
• If a model is re-registered, the error model is deleted. Register error models when re-registering a model.
1
In the Item Tab area, click [Model register].
When setting a new model, you do not have to click [Model register].
2
Use the drawing tools to specify the model registration range.
3
Click [OK] in the Figure setting area.
• [OK]: Changes the settings and returns to the previous menu.
• [Cancel]: Changes are discarded. Returns to the previous menu.
• [Apply]: Updates the settings without leaving edit window.
4
Click [Edge extraction], then confirm the edge extraction image.
If there is a break in the outline of the measurement object, adjust the edge level.
Reference: Adjusting the Edge Level (p.136)
5
If there is unnecessary profile information in the model, click [Mask register] to set the mask.
Reference: Mask any Unnecessary Items. (p.136)
6
To check the model display, click [Display model].
The registered model image is displayed in the image display area.
Note
• When a model is registered, the center coordinate of the model is
registered as the detection point coordinate. A detection point is
a point output as a measurement value.
134
ECM Search
Detection coordinate
Can be changed to an appreciate position.
Model
FH/FZ5 Processing Item Function Reference Manual