Measurement Parameters (Color Data) - Omron FH-3 Series Reference Manual

Measurement Parameters (Color Data)

Set the reference color and judgment conditions.
For color cameras:
1
In the Item Tab area, click [Measurement].
2
If necessary, check the "Normalization"
option in the "Correction condition"
area.
Normally, the factory default value will be
used. After changing a setting, check whether measurement can be done properly by performing an
actual measurement.
Setting item
Normalization
3
In the "Reference color" area, specify the
reference color.
This operation is not needed when there is a
check at "Auto update reference color." when
the region is registered.
Setting method
Color chart
R, G, B
Auto setting
FH/FZ5 Processing Item Function Reference Manual
Set value
[Factory default]
Specify whether to normalize the brightness in calculating the color
• Checked difference.
• [Unchecked] When checked, the result is not affected by the total brightness and only
the color tone can be detected.
Clicking the color chart displays the RGB values for the specified color at the bottom.
Set the RGB values with numbers.
If you click [Auto setting], the average color of the measurement region is displayed as the
reference color.
Description
Description
2
311
Color Data