Region Setting (Precise Defect) - Omron FH-3 Series Reference Manual

Region Setting (Precise Defect)

This item is used to set up the measurement area.
Use a rectangle, wide line, ellipse (circle), wide circle, wide arc or polygon to specify a measurement region for
[Precise Defect]. Up to 8 figures can be drawn.
Important
A mask cannot be made with only one region specified using Wide line, Wide circle, or Arc, as the figure.
PT
Wide line
Circumference, Wide arc
Rectangle, Ellipse (circle),
Polygon
1
In the Item Tab area, click [Region setting].
2
Use the Drawing tools to specify the measurement region.
Up to 8 figures can be combined.
3
Click [OK] in the Figure setting area.
• [OK]: Changes the settings and returns to the previous menu.
• [Cancel]: Changes are discarded. Returns to the previous menu.
• [Apply]: Updates the settings without leaving edit window.
4
When performing measurement in
region mode for wide line, wide circle or
arc in a single figure, check "Area" in the
Measure Mode area.
Note
In Precise Defect, the measurement mode depends on the number and type of registered region figures.
The method for creating elements differs depending on the measurement mode.
Reference: Measurement mode (p.373)
FH/FZ5 Processing Item Function Reference Manual
Selected when detecting defects and burrs of the measurement objects. Measurement can
be performed in region mode by checking "Measure in region mode".
Measurement
region
Selected when detecting defects and burrs of the circle measurement objects.
Measurement can be performed in region mode by checking "Measure in region mode".
Measurement region
Selected when detecting the overall defects of specified zones and measurement objects.
Description
Measurement region
Measurement
region
2
369
Precise Defect